тел: +359 888 100 273 email: office@grema3d.com |
|
PRINTER | LAYER HEIGHT | LAYER EXPOSURE (S) | # OF INITIAL LAYERS | EXPOSURE FOR INIT LAYERS |
---|---|---|---|---|
RGB LCD | 0.3 mm | 7~10 | 5~7 | 70~100 |
MONO LCD | 0.03~0.05mm | 2.5~4 | 5~7 | 50~80 |
DLP | 0.03~0.05mm | 2.5~4 | 5~7 | 50~80 |
Keep away from light and sealed at room temperature. Sunshine
contains a certain amount of UV light which would solidify photosensitive resin.
It is recommended to store the resin under 5°C -30 °C in a sealed container. Avoid any dusty or moist environment.
Shake well before using.
Avoid any direct sunlight during usage;
Do not put in the mouth.
Keep it away from the children and Pregnant women;
Wear gloves before use to avoid direct contact with the skin and
keep the room ventilated; Finished models are required to clean by high-concentration alcohol (>95%), IPA about 30 seconds or Ethyl acetate and post cure process may be needed for higher hardness;
Please filter the residual resin in vat back to the container if it would not be used over 48 hours.
Polluted residual resin would cause printing issues.